No.
Item
①
Hub control
②
Channel button
External trigger
③
button
④
Average button
Measurement
⑤
start/stop button
Measured value
⑥
display
※ When the external trigger is TRIG input (the trigger detects a rising edge), measurement
is conducted according to the settings in the measurement setup screen.
※ The external trigger (TRIG input) is non-voltage contact input.
ON
OFF
Select the hub unit(s) to display measurement values. You
can select up to 12 units.
Switch the measured value display between ON/OFF by
channel.
(ON)
Switch the use of external trigger between ON/OFF.
(External trigger ON)
This button is to display each average of V/T/H displayed
values in the dialog.
Switch measurement between start/stop.
(Measurement start button)
Displays measured values up to 12ch in the connected hub
unit.
If a reading is an abnormal value, please refer to 6.
Troubleshooting.
Description
(OFF)
(External trigger OFF)
(Measurement start button)
4. User Interface
35