Table of Contents
Advertisement
10. Put the installed chimneys on the cooker hood. Fix the Plate I to the wall by
using 2 (4mm x 40 mm) screws and wall plugs. Pull out extensible pipe till it
feeds through the hole on the wall.
Lift the inner chimney onto the plate II, fix the inner chimney to the plate II by
using 2 screws (4mm x 8mm).
After installation, make sure that the extractor is level to avoid grease collection
at one end.
11. Before usage, read all the instructions and make sure that the voltage (V)
and the frequency (Hz) indicated on the identification plate (found inside the
cooker hood) and all the data inside the appliance are exactly the same as
the voltage and frequency in your home. Then plug the power lead into the
power socket (unless you are hard-wiring in to the mains) and start the cooker
hood. .
√
12
X
Advertisement
Table of Contents
