Table of Contents
Advertisement
3. Insert the glass into the panel glove of
the cooker hood, then use 4 screws (4 x
25mm), inserting them through the 4 x
rubber cushions to fix the glass into the
cooker hood (see diagrams).
4. The 2 x air flaps should be installed at this stage, as access is easier before
the unit is wall mounted. On the top of the Hood Unit itself, where the air outlet
vent is located, the 2 x flaps should be carefully installed, bending very slightly so
the lugs at each end locate into the holes, enabling flaps to pivot upwards when
the unit is in operation, opening up the outlet fully for the air to pass through.
Please note: the small spindles/lugs at each end of each flap locate into the
holes on the housing, not the grooves above them:
8
Advertisement
Table of Contents
