Table of Contents
Advertisement
5.8. PIN CODE
Allows you to change the INSTALLER PIN code, to access both the installation
configuration parameters through the monitor's own screen and the configuration
through a web browser.
NOTES:
Make a note of the new PIN at your convenience. If you lose or forget your PIN, you
should contact FERMAX's Technical Department to receive instructions regarding its
recovery. All settings programmed into the monitor will be lost.
5.9. RESTORE
Use this functionality to remotely reboot the monitor, or to restore it to factory settings. In
both cases it will ask for confirmation.
RESTORE FACTORY SETTINGS: The monitor will automatically turn off and start up
with the factory settings:
GENERAL
• BLOCK: 1
• APARTMENT: 101
• MONITOR: 0
NETWORK
• IP: 10.1.1.1
• GATEWAY: 10.254.0.1
• MASK: 255.0.0.0
• INSTALLER PASSWORD:
6666
Any other parameters (sip, actuators, IP cameras, etc.) that have been configured will
also be lost.
REBOOT DEVICE: The monitor will automatically turn off and start up but retain all the
programming parameters it had previously.
When resetting, the device will lose connection with the PC. Refresh the website after
about 60 seconds to resume the connection.
Enter the current code, the new pin
and confirm it.
The new password can have
alphanumeric characters and has
no limitation on its length. However,
if the password does not contain
just 4 numerical digits it cannot be
used from the monitor interface.
Finally, select SAVE.
NEO MEET INSTALLER MANUA
21
Advertisement
Table of Contents
