Table of Contents
Advertisement
NOTE:
The RTSP route generally has the following format:
although it depends on the configuration, brand and model of the camera itself. Please
refer to the corresponding data sheet or technical information.
5.5. SIP
Use this setting to configure the SIP monitor as a SIP protocol-based terminal in cases
where the monitor is to be configured as an extension on a SIP server.
The available options are:
• ENABLE: Check this box if the SIP monitor is to be used as a SIP-based terminal.
SEARCH SIP STATUS: This button appears when enable SIP function, show:
SIP REGISTERED
SIP REGISTER FAILED
• SIP SERVER: Enter the name
or IP of the SIP server where the
monitor will register.
• DOMAIN: Enter the domain of
the SIP server
• OUTBOUND, STUN IP: Used for
the configuration of installations
where SIP server is on Internet.
Check
with
administrator.
• STUN PORT: Used for the
configuration
server-based installations. It is
usually port 5060. Check with
your network administrator.
• USER: Enter the SIP user name or extension to register on SIP server.
• SIP PASS: Enter the SIP server extension password.
18
NEO MEET INSTALLER MANUAL
rtsp://user:password@camera_IP_address
if the registers is successful or
if the registers is unsuccessful.
your
network
of
Internet
SIP
Nº CÁMARAS: Select the number
of cameras to be designated,
between 0 and 8. The form will be
adapted to the number of selected
cameras.
For each camera selected, indicate:
o CAMARA X: Name that will
appear on the monitors during
the display of the camera, for
better identification
o URL: RTSP path of the
selected camera.
Advertisement
Table of Contents
