Table of Contents
Advertisement
Enter the corresponding parameters and click SAVE to confirm.
NOTE:
Before setting these parameters, it is necessary to plan the installation (installation
project) in advance, considering the configuration of all the devices.
5.3. NETWORK CONFIGURATION
Allows the configuration of the different parameters of the LAN network.
IP: IP address to be assigned to this monitor.
MASK: Subnet mask corresponding to the LAN
GATEWAY: LAN gateway
DNS: DNS server address. In case of doubt, we recommend using the default value
8.8.8.8.
SOFTWARE IP: IP address of the PC where the MEET Management Software is
installed (if any).
SOFTWARE PIN: PIN ACCESS code used to access the MEET Management Software.
The default setting is 123456. Indicate the corresponding parameters and click on SAVE
to confirm.
NOTE:
The MEET system uses static IP addressing. This ensures that each device has a unique
IP address in the same installation.
If a mmonitor has an IP address already assigned to another device on the network, an "IP
CONFLICT" prompt will appear, along with the MAC of the conflicting device.
Both devices will not work properly until this issue is resolved.
5.4. IP CAMERA
Designate the IP camera or cameras, accessible on the NETWORK, that will be available
for viewing on this monitor.
NEO MEET INSTALLER MANUA
17
Advertisement
Table of Contents
