Table of Contents
Advertisement
The options available from this section are:
4.2. BASIC CONFIGURATION OF THE MONITOR
Touch the icon
Use the keyboard that will appear on the screen to enter the corresponding programming
parameters.
MONITOR SETTINGS
• BLOCK: Block number of the apartment where the monitor is installed.
• APARTMENT: Number of the apartment where the monitor is installed.
• MONITOR: Number (from 0 to 9) assigned to each of the monitors installed in the
same apartment, in the case that there are more than one. Otherwise, leave the
default value "0".
• SYNC CODE: Synchronisation code with the rest of the devices in the apartment.
Default value is 123456.
• SOFTWARE IP: IP address of the PC where the MEET Management Software is
installed (if any).
• SW PIN: MEET Management Software ACCESS PIN code. The default option is 123456.
10
NEO MEET INSTALLER MANUAL
Basic monitor configuration (IP addressing, LAN
configuration, block, housing, etc.)
Installation/desinstallation of ICON user functions.
Enable/disable user functions.
Configuring the built-in alarm settings.
Change the INSTALLER PIN code.
to access the basic configuration parameters:
Advertisement
Table of Contents
