Table of Contents
Advertisement
NETWORK SETTINGS
• IP: IP address to be assigned to this monitor.
• MASK: Subnet mask corresponding to the LAN.
• GATEWAY: LAN gateway.
• DNS: DNS server address of the LAN. In case of doubt, we recommend using the
default value 8.8.8.8.
After all data has been entered correctly, a confirmation message "SETTINGS SAVED"
will appear. Otherwise, re-enter the data correctly.
NOTES:
Before programming the monitors, it is necessary to plan the installation with the following
criteria:
• Assign a unique IP to each element of the installation (including the PC where the
MEET Management Software is installed, if any).
• All IP addresses must be in the same range.
• The LAN to be used must have an internet connection (if MEET ME call divert to
mobile is required) and be correctly configured.
Consult your LAN administrator if you have any questions regarding the configuration of
network parameters.
4.3. ALARM SETTINGS
Touch the icon
incorporated in the monitor, according to the installation carried out. (See section 2.4
Wiring of alarm and doorbell sensors).
For each of the alarm zones indicate:
TIPO: Choose between INSTANT, DELAY or PANIC
• INSTANT: The alarm will be triggered at the same time as the corresponding
sensor is activated. Alarm will sound even in the arming countdown.
• DELAY: The alarm is triggered at the same time as the corresponding sensor
is activated but the monitor will not produce alarm sound after the indicated time,
to give the user time to switch it off. Alarm will not be triggered during the arming
countdown.
• PANIC: The alarm will be triggered silently, i.e. by giving a warning to the control
station, but without alarm sound on the monitor.
to access the configuration parameters of the Alarm Centre
NEO MEET INSTALLER MANUA
11
Advertisement
Table of Contents
