Configuring the system
System controller configuration
Cascade settings
Call up with
■
å
■
"Configuration"
■
"Configuration"
"Parameter system controller"
■
"Cascade settings"
■
Fig. 25
Buttons and parameters:
■
"Cascade present:"
Is there a cascade? " Y"/"No"
■
"This heat pump is"
Is this heat pump a slave or a master?
"Heat pump 2 / slave 1"
■
If this heat pump control unit is the master, the
details of the slave must be entered here.
–
IP and Modbus address of the slave control unit to
be controlled
Cascade operating mode
–
Are the heating circuits extended by the second
–
system? "Y"/"No"
If "Y", up to 3 additional heating circuits are possi-
ble.
36
(cont.)
"Activate cascade"
■
Adopt settings
■
"Back"
One page back