Reverse Warning Buzzer Installation; Reverse Warning Buzzer Limit Switch (If Equipped); Testing The Reverse Warning Buzzer Limit Switch; Reverse Warning Buzzer Limit Switch Removal - Club Car Carryall 1500 2016 Maintenance And Service Manual

14

Reverse Warning Buzzer Limit Switch (If Equipped)

REVERSE WARNING BUZZER INSTALLATION

1. Install the reverse warning buzzer and secure it with two plastic rivets.
2. Connect the black wire from the wire harness to the negative (–) terminal on the buzzer.
3. Connect the red/white wire from the wire harness to the positive (+) terminal on the buzzer.
4. Lower and secure the hood.
5. Connect battery. See Side-Post Battery: Connecting the Battery – Gasoline/Diesel Vehicles on page 1-4.
See Top-Post Battery: Connecting the Battery- Gasoline/Diesel Vehicles on page 1-4.
REVERSE WARNING BUZZER LIMIT SWITCH (IF EQUIPPED)
See General Warnings, Section 1, Page 1-2.

TESTING THE REVERSE WARNING BUZZER LIMIT SWITCH

See Test Procedure 25 – Reverse Warning Buzzer Limit Switch (If Equipped) on page 12-36.

REVERSE WARNING BUZZER LIMIT SWITCH REMOVAL

1. Disconnect battery. See Side-Post Battery: Disconnecting the Battery – Gasoline/Diesel Vehicles on page
1-3.
See Top-Post Battery: Disconnecting the Battery- Gasoline/Diesel Vehicles on page 1-4.
2. Raise the hood.
3. Disconnect the wires from the reverse warning buzzer limit switch (Figure 14-7, Page 14-11).
4. Remove the screws, nuts, washers, and lockwashers that secure the limit switch.
5. Remove the limit switch.
2141
Figure 14-8 Reverse Warning Buzzer Limit Switch
Adjustment Slot
Page 14-12 2016 Carryall 1500/1700 and XRT 1550 Maintenance and Service Manual
ELECTRICAL COMPONENTS: DIESEL
2142
Figure 14-9 Reverse Warning Buzzer Limit Switch
(Properly Adjusted)
VEHICLES