Advertisement
GM
Vending, s.a.
• Unpack the machine.
Remove outside and inside packing (Elite 24 models).
• Level the machine properly.
Using the levelling knobs at the bottom of the machine, adjust height until the machine is perfectly level.
• Plug into mains.
Connect to a 220 Volt / 50 Hertz source. Turn the main switch on (located inside the machine, on the left
hand side, at the level of the collector). If the process has been carried out properly, the V-retainer should
move its paddles and the display and fluorescent light should turn on.
BUTTON
PROGRAMMING
• Adjust the time.
Using option 01.02 adjust machine clock time, month and year.
• Fill in machine warranty card..
Fill in machine warranty card giving the customer one copy and sending another copy to the factory.
This completes basic machine installation. Other options which may be of interest are:
• Joining slides.
Programming option 01.19 allows you to assign several buttons to several extractors and create the
combinations between slides and extractors that you wish.
• Machine lighting.
Option 01.06 allows you to control when the machine fluorescent light turns on and off. This allows you to
have it off outside opening hours.
• Customising the machine.
There are other programming options which allow clients to customise how the machine works.
C:\manuales\Elite\inglés\ELITEing10-02.DOC
MACHINE INSTALLATION
• Insert tobacco and change coins.
Put at least one cigarette pack in any slide and use the 00.00
programming option to put coins in the coin assembly so that they are
available for change. To go to option 00.00 you need to push the
programming button located on the display card (the card located at
the top, left-hand side inside the door).
• Set prices.
Use one of the three ways for setting prices (see programming
instruction manual) to set a price for each slide depending on the
brand it holds. Place brand labels in the button panel and on the front
part of the extractor, as well as price labels with the adequate figures.
All these labels are located in an envelope inside the machine.
• Explain to the customer.
Explain to the customer the basic working of the machine and how to
use its basic functions; i.e., programming options 1 to 10.
Pág 3 de 49
VERY IMPORTANT
Edición:09/02
Advertisement
