Advertisement
GM
Vending, s.a.
Once in this option (and with the printer connected) press channel 1. The
display shows 'r232' flashing and starts to send characters to the printer. When
this is finished it shows the value 09.05 again. You can print as many tickets
as you like.
Exit the sales data option by pressing the PROGRAMMING button, or
start again by pressing REJECT.
• Deactivate machine lighting. (00.06)
• Activate machine lighting. (01.06)
If you are in option 00.06 the fluorescent light in the front panel of the machine
will always be switched off. To activate it, just press REJECT and the machine
E l i t e
8
E l i t e
8
will change to option 01.06. Within this option, by pressing channel 1 the time
the machine has been switched on will appear on the display (in hours and
minutes, the latter flashing). To change the value use the first and second
push-button located in the top right corner of the machine (Channel 1). The
value increases or discrease each time the button is pressed. If REJECT is
pressed the hours flash and increase with Channel 1 and discrease with
Channel 2.
If you press REJECT again the time (in hours and minutes) the machine has
been switched off appear (the minutes flash). Change the minutes through
channel 1 and 2 and press REJECT again, the hour flashes and this can be
changed with channel 1 and 2. If you want the machine to be switched on all
the time, the timetable for switching on and off should coincide i.e. show the
same time. To exit this option, press PROGRAMMING.
If REJECT is pressed instead of PROGRAMMING you start again with hours
and minutes switched on.
• Inhibiting coins.
(OPTION WILL ONLY BE ACTIVATED WHEN THE HOPPER OR THE ESCROW
ARE ACTIVATED)
When REJECT is pressed the first type of coin appears on the display. If it is
inhibited it flashes. To change from one state to another, just press and let go
the first channel of product located top right of the machine. To change the
type de coin, press REJECT again. After visualize the last type of coin, the list
starts again with the first. When there are two types of coin with the same
value, the oldest is shown with its value and a full stop.
To exit press the PROGRAMMING button.
•
•
• Access code to programming levels.
To access other programming options (located at a higher level) enter
programming option 00.10. When you press any channel or REJECT push-
button, the code 0000 appears in the display. The code is between 0 and
9999.
To enter an access code, use the first four push-buttons located in the top right
corner of the machine. Each one of these represents a digit on the display.
After each keystroke in each channel, the digit corresponding to that channel
in a unit increases (when it reaches 9 it goes to 0, etc.). Once the code you
want to enter appears on the display, press the REJECT button to validate it. If
the code is incorrect the machine allows you to try again up to three times.
After that it exits the programming mode. If the code is correct the machine
enters the first programming option of the next level. The code is 1111.
• Programming of the codes in each product.
To program the codes of the products in each channel, enter programming
option 00.11. By pressing a channel the code of the product will appear on the
C:\manuales\Elite\inglés\ELITEing10-02.DOC
Pág 15 de 49
Edición:09/02
Advertisement
