Advertisement
GM
Vending, s.a.
?
C:\manuales\Elite\inglés\ELITEing10-02.DOC
right-hand corner of the machine. Each one represents a digit on the display.
With each keystroke in each channel the digit corresponding to that channel in
a unit increases, and when it reaches 9 it goes to 0, etc. Once you have seen
the code you want to enter, press the REJECT button to validate it. The
machine does not ask for verification of that code so it is best not to make a
mistake when entering it. Once the code is entered the machine changes to
the next programming option. If you press PROGRAMMING without validating
it with REJECT the original code remains.
• Deactivate hopper 1. (00.21)
• Activate hopper 1. (10.21)
Programming of the coin value in hopper 1
If you are in option 00.21 the machine will not use hopper 1 for coin returns.
When REJECT is pressed you pass to option 10.21, which activates hopper 1.
By pressing p1 you visualise the coin programmed at the time. If you want to
change its value just press p1 repeatedly and the coins that can be assigned
will appear on the display. The last value visualised will be the one assigned to
the hopper.
Press PROGRAMMING to exit this option.
• Deactivate hopper 2. (01.21)
• Activate hopper 2. (11.21)
Programming of the coin value in hopper 2
If you are in option 01.21 the machine will not use hopper 2 for coin returns.
When REJECT is pressed you pass to option 11.21, which activates hopper 2.
By pressing p1 you visualise the coin programmed at the time. If you want to
change its value just press p1 repeatedly and the coins that can be assigned
will appear on the display. The last value visualised will be the one assigned to
the hopper.
Press PROGRAMMING to exit this option.
• Desactivate programming bill value (00.22).
• Activate programming bill value (10.22).
(OPTION IS ONLY ACTIVATED WHEN THERE IS A BILL VALIDATOR IN THE
MACHINE AND IT IS OPERATING)
This option allow change the value of a the bills.
When the option is activated (11.22), push p1. On the display appears "bILL"
to indicate that the machine is waiting a bill.
If you insert a bill appears the actual value. You can change with the first five
push. To validate push REJECT and "bILL" appears again.
Press PROGRAMMING to exit this option.
Pág 20 de 49
Edición:09/02
Advertisement
