Advertisement
GM
Vending, s.a.
= 500
= 300
5 4
3
2
1
5 4
3
2
1
C:\manuales\Elite\inglés\ELITEing10-02.DOC
option 01.18. Within this option, when you press channel 1 the time (hours
and minutes) when the application of the discount/surcharge on sales will
appear (the minutes flash). To change the value, use the first push-button
located in the top right-hand corner of the machine (Channel 1). When you
press it its value increases. If you press REJECT the hours flash, and these
can be increased by using channel 1.
If you press REJECT again, the when the discount/surcharge on sales ends is
shown (the minutes flash). With channel 1 you can change the minutes, and by
pressing REJECT again the hour flashes (change the hours with channel 1).
If you want the machine to always sell at a discount/surcharge, the starting and
finish time should be the same. If you press REJECT again the
discount/surcharge percentage to be applied appears on the display. When
you press channel 1, this value increases one by one and with the channel you
discrease. This percentage admits values of up to 255. Discount is considered
up to 100, and above that figure it is considered a surcharge on sales.
To know the final price for the product the following formula is used:
Final price = Initial price * (percentage / 100)
To exit this option, press PROGRAMMING.
If you press REJECT instead of PROGRAMMING you start again, with the
time of application of the discount/surcharge on sales.
• Deactivate connection between channels and extractors. (00.19)
• Activate connection between channels and extractors. (01.19)
Programming of the connection between channels and extractors.
If you are in option 00.19 the machine will move (by default) the motors
associated to each push-button (in normal operation mode) according to the
type of machine (8, 12, 16 or 24 channels) i.e. following ex-works settings. To
see these settings, enter option 00.04. If, for any reason, you want to change
these settings just press REJECT and the machine will change to option
01.19. Within this option, when you press channel 1a vertical segment appears
on the display to indicate that the machine is in 'reading' mode. To link
channels just press the push-buttons corresponding to that channel, the
product detectors of the motors you want to connect (the order does not
matter, you can start with switches or push-buttons or mix them up) and
validate them by pressing REJECT. From the version of memory 2,21, it will
give a package of each channel that is united of alternative form. This process
is repeated until there are none left to connect, because if any motor or push-
button is overlooked they will not respond to any order to move. In normal
operation, if a channel has not been assigned instead of visualising its price,
the code E-__ appears on the display to indicate that it does not know which
extractor to move. The following is important to bear in mind: the machine
does not allow you to connect channels that have already been linked, nor
does it let you link channels with different prices.
IMPORTANT: Press PROGRAMMING to exit this option.
• Change of access code to programming levels.
To change the access code to other programming options at a higher level,
enter programming option 00.20. This option only allows you to change the
code entered in option 00.10. When you press any channel or the REJECT
push-button, code 0000 appears on the display. The code is a number
between 0 and 9999.
To enter an access code, use the first four push-buttons located in the top
Pág 19 de 49
Edición:09/02
Advertisement
