Advertisement
GM
Vending, s.a.
display. This product code is a number between 0 and 9999. If you do not want
to change it just press REJECT or the PROGRAMMING button. This second
action will take you to the next option of those available in the programming
mode.
To see a new code just press another channel.
If you want to modify a code, once it appears on the display you can change its
value by using the first four push-buttons located in the top right corner of the
machine. Each one of these represents a digit on the display. After each
keystroke in each channel, the digit corresponding to that channel in a unit
increases (when it reaches 9 it goes to 0, etc.). Once the code you want
appears, press the REJECT button to change another code. If REJECT or
PROGRAMMING is pressed before finishing the code change the value of the
code in the channel being changed will be the last one that appears on the
display.
• Programming of the codes in each product using the keyboard.
To program the codes of the products in each channel, enter programming
option 01.11. By pressing a channel the code of the product appears on the
display. This product code is a number between 0 and 9999. If you do not want
to change it just press PROGRAMMING or another channel.
If you want to change a code, once it appears on the display you can change it
by using the numerical keyboard. If the number entered is greater than four
figures, the value is automatically cancelled and the display sets itself to 0000.
In this case you have to re-enter the required value. If you press a different
channel or PROGRAMMING before finishing the code change, the value of the
code in the channel that was being modified will be the last one that appears
on the display. To exit press PROGRAMMING.
• Programming of the type of sale to be made.
When you enter this option the value 0X.12 will appear on the display. The
value X represents the current option of type of sale.
Each time REJECT is pressed, the type of sale to be made is changed
according to the following table:
500
00.12: Single sale.
+
300
300
+
01.12: Multiple sale.
02.12: Free sale.
.
To exit this option and pass to the next one after the value has been stored,
press PROGRAMMING. The stored value is the last one visualised on the
display.
• Programming for what the machine should do when change has run
out.
When you enter this option the value 0X.13 will appear on the display. X
represents the current option.
Each time REJECT is pressed the working mode of the machine is changed
when it has run out of change (according to the following table):
C:\manuales\Elite\inglés\ELITEing10-02.DOC
Pág 16 de 49
Edición:09/02
Advertisement
