Advertisement
GM
Vending, s.a.
26
8
15
C:\manuales\Elite\inglés\ELITEing10-02.DOC
• Programming of minimum coin levels.
Once inside option 00.15 (programming the minimum number of coins which
the coin return, below which the machine indicates that it has no change) just
press the channels (3 or 4 channels depending on the change giver coin
mechanism) located top right in the machine. Each one represents a tube with
a type of coin.
When you press one of them, the type of coin it contains appears on the
display (value of that coin). If you press again the minimum number currently
programmed appears. To change it just press that channel again, the minimum
goes to 4 coins and this figure increases by one each time the channel is
pressed until you reach the number of coins required (these values appear on
the display and are between 4 and 15 coins).
If you press the PROGRAMMING key you pass to the next programming
option. If you press another channel (containing a tube) the process is
repeated. The last value indicated on the display remains as the minimum.
• Escrow "V"
When you enter this option, the display shows the value 0X.16. X represents
the current option.
Each time REJECT is pressed the option is changed according to the following
table:
00.16: There is no
Escrow .
01.16: There is an
Escrow but it is not used.
02.16: There
an Escrow and it is
used.
To exit this option and pass to the next one while storing the value, press
PROGRAMMING, The stored value is the last one indicated on the display.
• Maximum credit/return value of coins.
When you enter this option, the display shows the value 00.17. If you press
REJECT the maximum value of money that can be recovered or admitted as
credit in each operation appears on the display. If you want to change this
value, just press REJECT again to reset it to zero. In successive keystrokes
the value increases until the required value is reached. To exit this option and
pass to the next one while storing the value, press PROGRAMMING again.
• Deactivate discount/surcharge on sales. (00.18)
• Activate discount/surcharge on sales. (01.18)
Programming of working hours and percentage of the discount/surcharge.
If you are in option 00.18 the machine will never apply discount/surcharge on
its sales. To activate this just press REJECT and the la machine will change to
01.18
Pág 18 de 49
is
Edición:09/02
Advertisement
