Advertisement
GM
Vending, s.a.
C:\manuales\Elite\inglés\ELITEing10-02.DOC
• Manual handling of motors.
To handle the motors in each channel manually, enter programming option
00.04. By pressing a channel the associated motors will move in sequence.
Each time a motor is moved the display will show the push-button number
which is being moved and the number of the motor (e.g. 07.07 push-button 7,
motor 7). This will flash slowly if the motor that is being moved is a slow one (if
it flashes stronger the motor is faster). If a slow motor has been replaced with a
fast one (or vice versa) this will be detected and the system will adapt to
operate with one or the other. This can be seen through the flashing, when the
motor moves a second or third time to check that the adjustment has been
made correctly. Once you stop moving a motor or fan, if this motor has
extracted a product incorrectly during a cycle the display will show this,
indicating the number of wrong cycles and the number of the motor (no
flashing). (E.g. 03.07 wrong cycles 3, motor 7). If this defective motor has
been replaced by another you can erase the number of errors by pushing the
REJECT push-button when the cycle is finished; The word Erase flashes on
the display, and if it is moved again you will see that its number of wrong cycles
is now 0. To exit this option and move on to the next one, press the
PROGRAMMING button.
.
• Manual handling of the hoppers and the escrow.
(OPTION WILL ONLY BE ACTIVATED WHEN THE HOPPER OR THE ESCROW ARE
ACTIVATED)
To handle the hoppers and the escrow 'V' manually, enter programming option
X1.04. 'X' is a value that indicates what is being moved at each moment
according to the following table:
01.04 Move hopper 1 (press p1).
11.04 Move hopper 2 (press p2).
21.04 Move escrow flap 1 (press p3).
31.04 Move escrow flap 2 (press p4).
We recommend not moving the hoppers to unload coins as this negatively
affects the accuracy of the sales data.
• Audit information of the machine.
This is used to visualise or print a ticket with the sales data of the machine,
broken down as follows: each product, change giver coin mechanism tubes,
money box ...
The following visualisation options are available:
00.05 Partial sales data on the number of products sold per channel:
These are sales made since the last time the partial sales data was reset.
Each time a channel is pressed, the number of products sold (corresponding to
that channel) appears on the display.
If the number is higher than 9999 (4 digits of the display) the figure will appear
in the display, advancing from right to left.
To pass to the next option, press the REJECT button.
• Partial sales data on product sales lost per channel:
These are sales lost since the last time partial sales data was reset.
Each time a channel is pressed the sales lost appear on the display (sales not
made) of the number of products corresponding to that channel.
If the number is higher than 9999 (the four digits on the display), the figure will
appear on the display , advancing from right to left.
To pass to the next option, press the REJECT button.
• Total sales data on the number of products sold per channel:
Pág 13 de 49
Edición:09/02
Advertisement
