Adjusting The Vertical Air Direction / 調整垂直風向 - Mitsubishi Electric V-251BZ-HK Instruction Manual

Method of Use / 使用方法
Method of Use / 使用方法
Adjusting the Air Direction by the baffle plate/ 通過導風板調整風向
About swing operation / 關於擺動運轉
120° 60°
Panel
Range of
面板
operating angle
運轉角度範圍
Set the baffle plate to swing operation (electric) and adjust
the air direction.
Swing operation (electric) can only be set for heating, drying,
and cooling operation.
將導風板設定為擺動運轉 ( 電動 ) 並調整風向。
只有暖房、乾燥和涼風運轉可以設定擺動運轉 ( 電動 )。
Press to start swing operation.
按此按鈕開始擺動運轉。
The baffle plate swings.
導風板擺動。
Press to stop swing operation.
按此按鈕停止擺動運轉。
The baffle plate stops.
導風板停止。
• When swing operation starts, the baffle plate swings in the
range between 60° and 120°. (During drying, swing operation
0°
stops after two minutes.)
Baffle plate
• To fix the swing angle, press
導風板
reaches the required position to stop the swing operation. When
the same operating mode is selected next time, the baffle plate
stops in the same place as the previous operation. The default
baffle plate set angle is 90°.
• The swing angle is stored for each operating mode.
• 擺動運轉開始時，導風板在60°至120°之間的範圍內擺動。
(執行乾燥時，擺動運轉會在兩分鐘後停止。)
• 若要固定擺動角度，導風板達到所需位置時請按
動運轉。當下次選擇相同的運轉模式時，導風板會停在與上一次
運轉相同的位置。預設導風板設定角度為90°。
• 擺動角度將儲存，用於每個運轉模式。
20
(continued / 續)
(continued / 續)
when the baffle plate
停止擺