How Do I Configure The Device Id On A Hhd - Xylem sensus AutoRead User Manual

How do I configure the Device ID on a HHD?

Setting the Device ID on a HHD allows you to configure the HHD to the desired device
number. For example, if the HHD is a loaner or if it was recently received from the repair
department, then the Device ID number will probably need to be configured.
1. Place the HHD in the charging stand. To eliminate any possible complications, it's best
to place the HHD in the first charging stand.
2. Enter the AutoRead program
3. Go to the tree view on the left side of the screen, and click once on the plus sign (+) to
the left of Serial Communications.
4. Below Serial Communications
again, perform one click the plus sign (+) which will show the communication ports. One
of the communication ports should have a red check mark and a plus sign to the left.
5. Click the plus sign (+) to the left of the communication port to show the next layer. This
will either say Standloop II or Standloop
stands you are using.
6. Perform one click the plus sign (+) to the left of
layer should show all of your currently configured charging stands.
7. Click the charging stand that has the HHD to be configured.
8. Go to the right side of the screen and perform one click the
the
Commands Box.
9. Click the Set Device ID
commands window.
10. A warning message should appear indicating the data on this HHD will be overwritten
and ask if you would like to continue. Answer
the HHD.
Note: If you have data on the HHD that has not been downloaded to AutoRead, please stop and
call AMR Technical Services for assistance.
will be your PC name or it will say
III, depending on the model of charging
Standloop
option and then click the
Yes
Local PC. Once
to show the next layer. This
Down arrow to the right of
Execute button above the
if it is OK to clear all of the data from
Appendix A: Frequently Asked Questions | 143