Xylem sensus AutoRead User Manual page 154

Field Protocols
Name
Flexnet HH/TRHH/
Meter RR
2 Leak
Detection
Consecutive
Reads
Flexnet HH/TRHH/
Meter RR
2 Leak
Detection
Threshold
Flexnet HH/TRHH/
Meter 2 RR
Reading
Resolution
Flexnet HH/TRHH/
Meter 2 RR
Type
Flexnet HH/TRHH/
Meter 2 RR
Units
Flexnet HH/TRHH/
Number of RR
Index Dials
Flexnet HH/TRHH/
Programming RR
Result
Flexnet HH/TRHH/
Programming RR
Unsuccessful
Reason
Flexnet HH/TRHH/
Sample RR
Rate
Flexnet HH/TRHH/
Service RR
Type
Flexnet HH/TRHH/
Signal RR
Noise Ratio
Flexnet HH/TRHH/
Transmit RR
Mode
Imp/Exp Function
Export The consecutive number of intervals
with an increase in consumption
before a leak is flagged on Port 2
of the transmitter. The interval is
defined by the sample rate. Works in
conjunction with the Leak Detection
Threshold. Expressed as 24, 36, 48,
or 72 hours.
Export The number of units that need to
pass per interval to flag a leak on
Port 2 of the transmitter. Works in
conjunction with Leak Detection
Consecutive Reads. Expressed as
Disabled, 1 count, 2 counts, or 10
counts.
Export The resolution programmed into the
transmitter for Port 2 expressed as a
power of 10.
Export Remote mount, single switch;
or Direct mount, dual switch as
entered through the programmer for
Port 1 of the transmitter.
Export The units of measurement
programmed into the transmitter for
Port 2. Expressed as Cubic Feet,
Cubic Meters, Liters, or Gallons.
Export Number of significant index
dials to be read electronically as
programmed into the transmitter.
May be 2, 3, or 4 dials.
Export Result of the programming attempt
on an endpoint. Possibilities include
Successful, Unsuccessful, NAK, and
Length Error.
Export Reason for the program failure.
Possibilities include No RF
Response From Module or No
RF Response From Module2 (this
indicates that a response was
received but from the wrong meter
ID.)
Export How often the transmitter reads
the register. Expressed in hours or
minutes.
Export W for water, G for gas, E for electric.
Export Signal strength of the transmitter to
the tower, expressed in dB.
Export The mode the transmitter has
defaulted to after programming:
Normal, mPass, or Boost. May also
be a combination of these preceded
by a corresponding ratio.
Max
Width
15
15
10
30
16
10
50
35
15
1
15
15
Appendix B: Import and Export Field Names | 154
Notes