Features - CNC4PC C25XP User Manual

____________________________________________________________________________

FEATURES

1.0
• Can ships with the Ethernet Smoot Stepper Motion Controller installed
when purchased as a bundle.
• Built-in PWM-Based Speed Control and Two Built-in Electromechanical
Relays with NO and NC positions for spindle control.
• The system monitors:
- E-Stop
- Safety Charge Pump.
• Electromechanical Relay with NO and NC positions for general purpose
(Port_2 16 or 17, jumper-selectable).
• Microcontroller based SCHP (Safety Charge Pump).
• Optoisolated inputs working at 5-24VDC.
• Uses a single +10 to +30VDC to power the system. It generates the isolated
voltage for the spindle control circuit and +5vdc for circuits using TTL
logic.
• Status LEDs on all input and Output connections.
• DIN Rail mountable.
• Open Collector Outputs pins 1, 14, 16, 17.
• Screw-On connections for all terminals.
• Status LEDs for enable.
• Available installers and configuration files that configure all the functions
of the board.
___________________________________________________________________________
User's Manual Page 1