Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for CNC4PC C34TSM
Summary of Contents for CNC4PC C34TSM
- Page 1 USER’S MANUAL VER. 1 C34TSM BOARD Rev. 1 APRIL, 2021...
-
Page 2: Table Of Contents
USER'S MANUAL TABLE OF CONTENTS Page # Contents OVERVIEW ........................1 FEATURES ........................1 BOARD DESCRIPTION ....................2 JUMPER TO SELECT THE ENABLE ................2 JUMPER TO SELECT THE DIFFERENTIAL..............3 JUMPER ALARM TO SELECT ACTIVE LOW OR ACTIVE HIGH ........3 ALARM TERMINAL ......................3 STEP SERVO PROGRAMMING ..................4 WIRING SAMPLE ......................5 9.1 Diagram of connection with input signals Step &... -
Page 3: Overview
OVERVIEW This board interface is used for the connection between C82, C76, M16D, C35S and TSM23S Closed Loop Stepper. FEATURES • CONN 28 POS connector for Connection of Driver. • RJ45 Connector for Axis. • Encoder Output. • Select Jumper for Hard Enable or Soft Enable. •... -
Page 4: Board Description
BOARD DESCRIPTION JUMPER TO SELECT THE ENABLE Use Software Enable to keep the driver active only while the system is active. Set of jumpers as shown in the image. SOFT ENABLE HARD ENABLE Use Hardware Enable to keep the driver enabled all the time. -
Page 5: Jumper To Select The Differential
JUMPER TO SELECT THE DIFFERENTIAL If using Differential Signals, it is required to use the connector: DIFERENTIAL STEP & DIR JUMPER ALARM TO SELECT ACTIVE LOW OR ACTIVE HIGH 1-2: ACTIVE HIGH 2-3: ACTIVE LOW ALARM TERMINAL User’s Manual Page 3... -
Page 6: Step Servo Programming
STEP SERVO PROGRAMMING Step-Servo Quick Tuner 3 User’s Manual Page 4... -
Page 7: Wiring Sample
WIRING SAMPLE 9.1 Diagram of connection with input signals Step & Dir and C76. User’s Manual Page 5... -
Page 8: Diagram Of Connection With Input Signals Differentials C74 And C76
9.2 Diagram of connection with input signals Differentials C74 and C76. User’s Manual Page 6... -
Page 9: Pinout
SOFT_EN ALARM DIR+ 24VDC 5VDC Note: * Servo ON and Alarm signals are related to the RJ45 pin 5 of the C34TSM board, but It is connected directly to this pin. RJ45 for Encoder 28 POS PIN RJ45 PIN FUNCTION User’s Manual... -
Page 10: 11.0 Dimension
11.0 DIMENSION All dimensions are in Millimeters. DISCLAIMER Use caution. CNC machines can be dangerous machines. Neither DUNCAN USA, LLC nor Arturo Duncan are liable for any accidents resulting from the improper use of these devices. This product is not a fail-safe device and it should not be used in life support systems or in other devices where its failure or possible erratic operation could cause property damage, bodily injury or loss of life.