Wiring In The Housing T13 - Endress+Hauser Liquicap M FTI51 Operating Instructions Manual

Wiring
!
!
40
4.3

Wiring in the housing T13

To connect the electronic insert to the power supply, proceed as follows:
a. Unscrew the housing cover (1).
b. Remove the cable gland (2) and insert the cable (3).
c. Ground the shield (4) on both sides!
a. + b.
2
3
Note!
The connection shown under (c.) depends on the type of protection ordered. This illustration shows
the terminal module for EEx d. For connection in a separate connection compartment, the same
connection descriptions apply as for the electronic inserts.
Note!
All further steps depend on the specific electronic insert used, and are described on the following
pages:
FEI52→ Page 42
FEI53→ Page 43
FEI54→ Page 44
FEI55→ Page 45
FEI57S→ Page 46
Liquicap M FMI51, FMI52
c.
1
1 2
L00–FTI5xxxx–04–06–xx–xx–004
Endress+Hauser
4