Performing A Firmware Update - Fluke SV600 Series User Manual

SV600 Series
Users Manual, Rev. 2.1, Nov 2021
Select "Use a Static IP address" if you want to run the SV600 in either mode 3 or 4 as described in section
4.2 Connecting a
•
IP address: The static IP address that the SV600 should use
•
Subnet mask: The subnet mask of the network the SV600 is (going to be) connected to
•
Gateway: The gateway address of the network the SV600 is (going to be) connected to
•
Primary and Secondary DNS Address: The IP addresses of the primary and secondary DNS server on
the network.
After the device has been configured, you will need to reload your browser window since the IP address of the
SV600 has changed. Depending on your network setup and the values you have entered, you might also need to
change the configuration of your network adapter before you can reach the SV600 again. Ask your network
administrator for assistance.
Currently all values need to be specified. If you do not need one of the values, just leave it at the default
Manually setting a static IP Address wrongly can lead to the device becoming unreachable. Make sure you

4.4 Performing a Firmware Update

Before you start:
The following steps assume you have already completed the device setup as described in section 4.3
SV600, page 17, and can access the device dashboard.
Step 1
In the device dashboard go to the "Device Configuration" page and click on Firmware Update.
Step 2
On the Firmware Update page, click "Click here to select a file". A file selection menu will appear.
20
SV600, page 16. You will need to specify the following:
setting. If you don't know what these settings mean, contact your network administrator.
configure the device correctly or ask your network administrator for help.
Note
Note
Setting Up