Fluke SV600 Series User Manual page 19

Installation 4
Setting Up SV600
http://100110001
Step 6
Set the device coordinates and relevant installation information such as angles and target distances (if known)
http://100110001
Step 7
Go back to the "Device Configuration" page and click on Networking.
http://100110001
Step 8
In the Network page set the preferred network settings according to your project.
http://100110001
Select "Obtain IP address via DHCP / Auto IP" (the default) if you want to run the SV600 in either mode 1 or 2 as
described in section 4.2 Connecting a SV600, page 16. No additional configuration is required.
19