Table of Contents
Advertisement
2.4.4 Scenario – A24M and Six A48 Devices
The following picture shows the sample connection between six A48 devices and one
A24M device. Here we take PC-1, PC-2 and PC-3 as the examples that connecting to one
A48 directly and wanting to access the Internet through A24M device.
In the above picture, the user of PC-3 wants to use phone and access the Internet at the
same time; yet PC-1 and PC-2 just want to access the Internet through the connected
Slave and Master devices. As for the connection, please follow the steps below:
1.
Connect PC-3 to number 9 of MDF-1, PC-2 to number 5 of MDF-1 and PC-1 to
number 1 of MDF-1 with Ethernet cable).
Connect the MDF-1 to Line port of the Slave Device -1.
2.
3.
Connect the Phone port of the Slave Device-1 to the matching connector (in this case,
it is number 9, be careful and not to misconnect) to MDF-2 which will be connected
to PSTN. This step is just useful for PC-3 for the user wants to call out through the
Slave Device-1.
Connect G1 or G2 port of the Slave Device-1 and G6 port of the Master device with
4.
Ethernet cable. As to the connection among the Master device and Slave Device-2 to
Slave Device-6, please refer to arrow indication shown on the picture.
Connect the Master device and ISP with Fiber cable through G3 or G4 port.
5.
With such connection, all the users of the PCs (connecting to the Slave devices) can
6.
access the Internet through G3 or G4 connector of the Master device. Yet only PC-3
can call out with a telephone set directly.
Such connection allows 168 ADSL CPE routers (24 from the Master device and 144 from
the Slave Device-1 to Slave Device-6) to connect to outside Internet via the Master device
at one time.
User's Guide
18
Advertisement
Table of Contents
