Draytek VigorAccess-A48M-2-SFP-A-1-AC User Manual page 46

GS Standard
Annex Type
Dmt Config Mode
Upstream Start Bin
Upstream End Bin
Downstream Start Bin
Downstream End Bin
Downstream Minimal INP Parameter used to specify the minimum impulse noise
Upstream Minimal INP
Interleave Depth
Downshift SNR Mgn
Upshift SNR Mgn
Min Downshift Time
Min Upshift
User's Guide
This parameter defines what DSL capability will be use
after training.
This parameter defines what ADSL annex standard to be
used.
This parameter defines what frequency division mode to
be used.
The lowest bin number allowed for upstream signal.
The highest bin number allowed for upstream signal.
The lowest bin number allowed downstream signal.
The highest bin number allowed for downstream signal.
protection for the downstream bearer channel.
Parameter used to specify the minimum impulse noise
protection for the upstream bearer channel.
Minimum interleaving depth supported by the customer's
hardware.
Configured Signal/ Noise Margin (SNR) for rate
downshift. If the noise margin falls below this level, the
modem should attempt to decrease its transmit rate.
Configured Signal/ Noise Margin(SNR) for rate upshift. If
the noise margin rises above this level, the modem should
attempt to increase itis transmit rate.
Determine the minimum time that the current margin is
below Downshift SNR Mgn, before a downshift occurs.
Determine the minimum time that the current margin is
below upshift SNR Mgn, before a downshift occurs.
38