Table of Contents
Advertisement
1.3 Panel Explanation
The connectors on the front panel for the VigorAccess A48 is shown below:
Interface
FAN MODULE
DC1 ~ DC2
FUSE-1 ~
FUSE-2
ALARM PORT
CONSOLE
G1 – G2
G3 – G4
FR (Factory
Reset)
PSTN
LINE
Warning:
The laser energy of the fiber optic communication channels in the single-mode
will be harmful when operate, especially to the eyes. During normal operation
with cable connection, this energy is confined to the cable with no danger
present.
Never stare
use.
In addition, below shows the cables used in different connectors：
Name
Power Cord
RJ45 Cable
Serial Cable (Console)
G3-G4 Cable
Description
Support hot-swappable
DC power connector (dual feed)
Fuse-1 maps to DC1 and Fuse-2 maps to DC2.
An alarm relay with RJ45 interface can connect to buzzer when the
FAN is out of order.
A RS232 serial interface is used to connect a local management
computer.
The subtend interface with RJ45 interface is Gigabit Ethernet
connection.
Slots used for SFP module.
A reset button is used to reset system, and then IPDSLAM will
operate by default configuration.
Connected to PSTN normally.
Connected to twist pair of subscriber line which connects ADSL
devices or telephones for users.
into an optical cable or connector when the connector is not in
Type, Color
Cord, Black
Wire,
RJ45 connect to
Buzzer
RS232, Grey
LC/RJ45,
Yellow/Orange
Connected to
DC-1 or DC-2
ALARM PORT connection.
PC RS232 port for CLI.
Gigabits Fiber Optical Interface
Interconnection.
9
User's Guide
Advertisement
Table of Contents
