Rep 1.22 Exit Roll And Bushings - Xerox Phaser 3052 Service Manual

4. Release the WNPC PWB from the latches and remove it
WNPC PWB
Figure 2 WNPC PWB (Underside of Top Cover)
Replacement
Install the components in the reverse of removal.
Repairs
REP 1.21, REP 1.22
(Figure 2).

REP 1.22 Exit Roll and Bushings

Parts List on PL 4.3
Removal
1.
2.
3.
Replacement
Install the components in the reverse of removal.
June 2014
4-32
Switch Off the Printer and unplug the Power Cord.
Remove the following covers:
a. Remove the Left and Right Side Covers
b. Remove the Rear Cover (REP 1.4).
c. Remove the Top Cover (REP 1.3).
Remove the Exit Roll and Bushings (Figure
a. Remove the Drive Gear, release the latch.
b. Remove the Bushings (2), release the latch and rotate the bushing.
c. Remove the Exit Roll.
Exit Roll
Bushings
Drive Gear
Figure 1 Exit Roll and Bushing (Top View)
(REP 1.2).
1).
Xerox® Phaser® 3052/3260 Service Manual