Putting Into Operation; Operating Modes - Nibe Drazice Aqua HP 250 Operating And Installation Manual

5.4

PUTTING INTO OPERATION

Before starting, check whether the installation is set up according to the recommendations and that
everything is in conformity, then you may plug your equipment to the power supply.
After switching on your equipment, you should wait a few seconds until the controller begins to work.
Then you may start your equipment following these instructions:
Controller ON
Note 1: The LED on the display indicates the status of your equipment. When is blinking means that your
equipment don't have any order to work, if the LED is ON and no blinking, your system is working with the
order that was given.
Note 2: To restart the appliance, switch it off and switch on again using the key ON/OFF.
5.5

OPERATING MODES

The AQUA HP is programmed to work in 3 main running modes: ECO, AUTO, BOOST. The equipment can also
work in LAT (protection of the compressor) and TCC (alternative energy source).
Mode Symbol
ECO
AUTO
BOOST
LAT
TCC
System is shut OFF
Press key ON/OFF
Normal running as Heat Pump
Optimized management of running of Heat Pump and/or
Electrical Heater (backup)
Running of Heat Pump + Electrical Heater (backup)
Running of Electrical Heater (backup)+ Fan
Running of Heat Pump + Electrical Heater (backup)
Press key COMP to start
up the system
Function
- 23 -