Table of Contents
Advertisement
The water you use may contain impurities and/or substances damaging to the system and even
harmful to your health. Make sure you use water with quality fitting for home consumption.
The following table indicates some parameters that, when exceeded, must be chemically
treated.
DANGER
WARNING
4.6
CONDENSATE
During operation, condensation may occur. These condensates are collected in the drip tray and drained
through a hole at the back of the tray. The installer must connect the condensate hose supplied by the
manufacturer and direct the condensates to the drainage system or drainage siphon.
The condensate hose must not be bent/pressed and must be placed where it best suits
the proper flow of condensates
WARNING
4.7
ELECTRIC CONNECTIONS
The thermodynamic equipment must be plugged to the power supply only after filling the storage water
heater. The thermodynamic equipment comes with a mains cable, to be connected to an earthed monophase
voltage (1/N/PE ̴ 2 30V/50 Hz). The connections must comply with the standards of installation in effect in the
territory or country where the thermodynamic equipment has been installed
The installation includes:
•
Bipolar circuit-breaker with connection cable with section equal to or exceeding 2.5 mm
•
Protection differential circuit breaker of 30 mA
If the power supply cable is damaged, it must be replaced by the manufacturer, by its custom-er service,
or by staff with similar training.
Hardness (°dH)
3.0 to 20.0
6.5 to 8.5
3.0 to 20.0
<6.5 or >8.5
<3.0 or >20.0
pH
Treatment
No
Yes
-
Yes
2
- 18 -
Advertisement
Table of Contents
