Table of Contents
Advertisement
4.1.7 Pressure Reducing Valve *
The pressure reducing valve must always be installed upstream from the safety device, and ready to activate
in situations when the pressure in the circuit exceeds 3 bar (0.3MPa). This valve comes with a pressure gauge.
* Parts that are not delivered by the manufacturer. Their delivery and installation must be performed
by the installer.
4.2
DRAIN PAN
The equipment should not be installed over an area where drains from the tank or its connections could
cause damage in the adjacent area or on the lower floors of the structure. For the aforementioned reasons,
it is recommended to place a drain pan under the equipment.
It is important that the pan has a flow channel with a minimum diameter of 3/4''.
4.3
LOCATION
When placing the equipment in its position, bear in mind possible future interventions.
Make sure that there is at least the following free space around the equipment:
- 12 -
Advertisement
Table of Contents
