Commissioning The Safety-Related Brake - Siemens SIMOGEAR 2332 Original Mounting And Operating Instructions

Dangerous voltages
Can result in death, physical injury or material damage. Observe the following safety
information before connecting-up the machine:
• Only qualified personnel is permitted to work on the machine.
• Only perform work when the machine is stationary.
• Isolate the machine from the power supply and take measures to prevent it being
• Check that the machine really is in a no-voltage condition.
• If you have loosened terminal blocks, rectifiers and/or similar parts when electrically
NOTICE
Malfunctions
It must be ensured that there are no foreign bodies, dirt or moisture in the terminal box.
The terminal box must be sealed so that dust and water cannot enter.
Seal the terminal box with the original seal. Seal cable entries to the terminal box and other
open cable entries with an O-ring or suitable flat gasket.
Do not damage the terminal box or other functional parts inside the terminal box.
3.6

Commissioning the safety-related brake

Inadequately qualified personnel
If the safety-related brake is electrically installed by inadequately qualified personnel, then
the functional safety will be disabled.
Only qualified personnel are authorized to carry out the work.
Such personnel must be trained in:
• Topics relating to functional safety
• Legislation, safety regulations and standards for functional safety
• The content of the detailed operating instructions provided
SIMOGEAR 2332 - Safety-related brake
Operating Instructions, 11/2021, A5E51390096A/RS-AA
DANGER
switched back on again. The same applies for auxiliary circuits.
connecting the motor, then secure these components back in the terminal box. See the
diagram below.
WARNING
Ensuring functional safety
3.6 Commissioning the safety-related brake
31