Commissioning; Safety Instructions For Commissioning - Siemens SIMOTICS T-1FW6 Operating Instructions Manual

Commissioning

The following information refers to commissioning the hardware components. Siemens
provides commissioning support through its Technical Support organization.
The motor can only be commissioned when it has been installed and integrated in a
functioning system. The commissioning documentation of all the system components must
be taken into account for the commissioning.
7.1

Safety instructions for commissioning

Risk of death and crushing as a result of permanent magnet fields
Severe injury and material damage can result if you do not take into consideration the safety
instructions relating to permanent magnet fields.
• Refer to Chapter "Danger from strong magnetic fields (Page 28)".
injury and material damage if EMC safety requirements are not observed
Risk of death, serious personal injury, and/or material damage can occur if a machine that does
not fulfill the recognized EMC safety requirements is commissioned.
• Plants and machines with converter-fed low-voltage three-phase motors must fulfill the
• The plant engineer is responsible for ensuring that installation is carried out in an EMC-
1FW6 built-in torque motors
Operating Instructions, 09/2022, A5E52220812B AA
WARNING
WARNING
protection requirements of EMC Guideline 2014/30/EU.
compliant manner. Use shielded signal and power cables. Apply the EMC installation
guideline of the converter manufacturer. For Siemens converters, this is available under
document order No. 6FC5297-□AD30-0□P□.
7
109