Safety Instructions; Intended Use; Qualified Personnel - M&C PSS Series Instruction Manual

3

SAFETY INSTRUCTIONS

Follow these safety directions and instructions regarding installation, commissioning and
operation of the equipment:
Read this manual before commissioning and operating the product. Make sure to follow all safety
instructions.
Installation and commissioning of electrical devices must be carried out only by qualified skilled
personnel in compliance with the current regulations.
The installation and commissioning of the device must conform to the requirements of VDE 0100
'Regulations on the Installation of Power Circuits with Nominal Voltages below 1000V' and must be in
compliance with all relevant regulations and standards.
When connecting the device, make sure that the mains voltage is correct as specified on the nameplate.
Protection against damages caused by high voltages:
Disconnect the power supply before opening the device for access. Make sure that all extern power
supplies are disconnected.
Operate the device only in the permitted temperature and pressure ranges. The location class according
to DNV-GL can be found in the technical data of this instruction manual.
Check that the location is weather-protected. It should not be subject to direct rain or liquids.
This device is NOT certified to be installed or operate in explosive hazardous areas.
Installation, maintenance, inspections and any repairs of the devices must be carried out only by
qualified skilled personnel in compliance with the current regulations.
3.1

INTENDED USE

This product is intended for use as a gas conditioning device for gas treatment on ships. The location
class according to DNV-GL can be found in the technical data of this instruction manual.
Do not use the unit for any other purpose than for this purpose.
Improper use can lead to serious injuries, see the safety instructions at the appropriate place in this
manual.
3.2

QUALIFIED PERSONNEL

The gas treatment device must be operated only by qualified personnel.
Use of the system by unqualified persons or failure to observe the warning instructions in this instruction
manual or on the device/cabinet itself may result in serious physical injuries and/or material damage.
The instruction manuals for the individual components must also be observed. Only qualified personnel
are allowed to use and maintain this device.
6 SS-M05_Marine | 1.01.00 www.mc-techgroup.com