Changing Contact Pulleys And Springs; Figure 9 Different Pump Tube Sizes; Figure 10 Disassembly Of Pump Head And Driver - M&C PSS Series Instruction Manual

7. Put the conveying belt
8. Press conveying belt at the recessed grips and simultaneously turn the S-bolt
until it snaps;
Switch on pump.
9.
Figure 9 Different pump tube sizes

15.2.2 CHANGING CONTACT PULLEYS AND SPRINGS

Note
Follow these instructions to change the contact pulley and springs:
1. Disconnect the peristaltic pump from power supply;
2. Unscrew nuts of the pump head (wrench size 5.5)
1 Pump head nuts
4 Groove
Figure 10 Disassembly of pump head and driver
3. Remove the pump head
4. Now the driver can be removed from the pump head and is ready for maintenance.
www.mc-techgroup.com
with the new tubing

While mounting, make sure that the center of rotation and the driver
are aligned.
Use genuine spare parts only!
2 Pump head
5 Driver (roll carrier)
from the motor shaft

SS-M05_Marine | 1.01.00
into the dovetail guide of the pump body;

;

3 Springs
6 Collar of the shaft bore
anticlockwise

31