Guard Installation - IBEX TS51C Assembly Manual

ASSEMBLY GUIDE

GUARD INSTALLATION

Install the plastic PTO guards as shown in the images that follow. They are easier to install
before assembling the mower.
The larger guard is installed on the gearbox facing the tractor.
Figure 4 larger guard installed on the gearbox facing the tractor
The smaller guard with a cutout is installed on the 3 point hitch gearbox on the other side,
with the cutout facing the rear. This cutout provides space to allow the PTO shaft to pivot to
90 degrees when the mower is switched to transport mode.
Figure 5 the smaller guard with the cut-out facing the rear (cutout may look different on your machine)
The other small guard without a cutout is installed at the drum unit PTO spline.
2021-1.2 IBEX EQUIPMENT CO. 5