IBEX TS51C Assembly Manual page 20

ASSEMBLY GUIDE
Figure 32 front guard has six holes
The eight sets of hardware shown in Figure 33 are used to fasten the guard frames. Align the
pin in the front frame to the hole in the rear frame, then bolt on. Do not install the optional
bumper guard yet (the double-T shaped frame seen in Figure 34), as the curtain must be fitted
first. You will need two wrenches that are 17mm for these nuts and cap screws.
Figure 33 eight sets of fasteners used for attaching guard frame
You can now install the optional bumper guard if desired. The bumper guard can help
somewhat to cut certain taller crops more efficiently. Slots must be cut out of the curtain to
accommodate the two mounting bars as shown in Figure 34.
Figure 34 curtain installed with 2 holes for toe guard facing forward
2021-1.2 IBEX EQUIPMENT CO. 19