Download Print this page
IBEX TX31 Quick Start Manual

IBEX TX31 Quick Start Manual

Wireless push button kit
Hide thumbs Also See for TX31:

Advertisement

Quick Links

QUICK START GUIDE
● Open the Pelican Ruck R40 Case (Fig. 1) by lifting out and up on the side clamp
from the bottom. The case is built with tight tolerances, so opening and closing will
be tight. It will loosen up a bit over time with use.
● Turn the battery on by flipping the switch to the on position (Fig. 2). Green LED
indicators will light up to display battery life when the battery is on.
2022-01.0
TX31 Wireless Push Button Kit
Fig 1.
Fig 2.
IBEX EQUIPMENT CO

Advertisement

loading

Summary of Contents for IBEX TX31

  • Page 1 QUICK START GUIDE TX31 Wireless Push Button Kit ● Open the Pelican Ruck R40 Case (Fig. 1) by lifting out and up on the side clamp from the bottom. The case is built with tight tolerances, so opening and closing will be tight.
  • Page 2 If this feature keeps tripping, there is a short in the circuit and that must be addressed before resetting this function again. Check that all wires are clean and not arcing or touching each other. 2022-01.0 IBEX EQUIPMENT CO...
  • Page 3 LED light on the relay (Fig. 5). The light should stay on after the A button is pressed. Press the A button again and the red LED on the relay should turn off. Fig 5. Location of relay LED 2022-01.0 IBEX EQUIPMENT CO...
  • Page 4 (Fig. 6 & 7). If the alarm sounds when the switch is pressed your system is 100% operational and ready to bale. Fig 6. Bale full switch for twine baler Fig 7. Bale full switch for net baler 2022-01.0 IBEX EQUIPMENT CO...
  • Page 5: Frequently Asked Questions

    ● If you’d like the B button to control the lift gate as well as the A button, repeat the previous steps and press B instead of A. 2022-01.0 IBEX EQUIPMENT CO...
  • Page 6 Fig 9. How long will the battery last? Should I turn it off? How often should I charge it? ● The battery will charge in just a few hours from 10%-100% via the provided wall outlet charger. 2022-01.0 IBEX EQUIPMENT CO...
  • Page 7 You can pull the case to remove it from the baler and relocate it as desired. However, be careful as the magnet is very strong and has the potential to smash fingers and cause harm if not handled with caution. 2022-01.0 IBEX EQUIPMENT CO...