Guard Installation - IBEX TS51C Assembly Manual

ASSEMBLY GUIDE
Figure 30 restrictor plate with hardware
Install two each of the odd-shaped thick washers and smaller flat washers as shown in Figure
31. Any additional small flat washers are spares. The handle ("pivot restrictor handle") should
be tightened during transport only. During mowing, the handle is loosened so that the mower
pivots freely within the range allowed by the slot in the restrictor plate.
Figure 31 pivot restrictor plate and handle shown installed from side

GUARD INSTALLATION

The front guard frame has 6 holes and a pin that slides into the tubing of the rear frame as
shown.
2021-1.2 IBEX EQUIPMENT CO. 18