IBEX TS51C Assembly Manual page 9

ASSEMBLY GUIDE
Figure 10 blade tool
Install the blades so that the angled edges are sloped downward. Position the blade tool so
that the two identical prongs are inserted between the two discs of the drum. Then raise the
arm so that the pin of the tool inserts into the slot on the upper disc. Pivot the tool up until
there is sufficient clearance, install the blade, and let the tool arm down.
The drum unit may need to be raised higher in order to have enough clearance to angle the
tool so that the two prongs fit below the upper disc. Once installed, be sure the blade is on the
pin and swings freely.
For safety purposes, never place your hand or fingers inside the opened space between the
discs.
Figure 11 installing a blade
2021-1.2 IBEX EQUIPMENT CO. 8