IBEX TX31 Installation Manual

Drawbar add-on kit

Hide thumbs Also See for TX31:

Download this manual

INSTALLATION GUIDE

 Align the end of the drawbar shown in (Fig. 1) with the baler's top link bracket.

The drawbar will fit inside the baler's top link bracket and will be supported by

the welded tabs on each side. Once aligned, you can insert the top link pin

through the baler's top link bracket going through the drawbar's holes. Secure

the top link pin with a retaining clip seen in (Fig. 2).

Figure 1

 Locate the crossbar with multiple holes and category 1 pins on each end. Attach

this crossbar to your tractor's lower three point hitch lift arms by inserting the

pins into the lift arms as shown in (Fig. 3). Make sure to secure them with the

retaining clips once installed (Fig. 4).

2022-1.0

TX31 Drawbar Add-on Kit

Figure 2

IBEX EQUIPMENT CO

Page 1 INSTALLATION GUIDE TX31 Drawbar Add-on Kit  Align the end of the drawbar shown in (Fig. 1) with the baler's top link bracket. The drawbar will fit inside the baler's top link bracket and will be supported by the welded tabs on each side. Once aligned, you can insert the top link pin through the baler's top link bracket going through the drawbar's holes.
Page 2 (Fig. 6). Figure 5 Figure 6  Attach the new, longer PTO shaft that came with the drawbar kit to the baler and then to the tractor. Ideally, you should have a minimum of 3 inches of 2022-1.0 IBEX EQUIPMENT CO...
Page 3 3-point hitch lift arms to keep them from sagging. First, connect the large clevis onto the crossbar in the next open hole and secure it with the safety pin and retaining clip as seen in (Fig. 8). 2022-1.0 IBEX EQUIPMENT CO...
Page 4 Attach the second smaller clevis to the other top link bracket. Select a different chain link as needed to ensure that the chain is mostly snug, as seen in (Fig. 9). Figure 9 2022-1.0 IBEX EQUIPMENT CO...
Page 5  The kit comes with longer pull ropes for the tailgate release and net feeding (for net wrap balers). Check to see if you can reach the existing ropes with the drawbar kit installed and, if not, replace with the longer ropes. 2022-1.0 IBEX EQUIPMENT CO...