Transport Lock; Pto Shafts - IBEX TS51C Assembly Manual

ASSEMBLY GUIDE
Figure 25 nut and washer installed on pivot pin

TRANSPORT LOCK

Install the transport lock for the spring arm as shown. Use a mallet to drive the rubber grip
over the pin as shown. There are two rubber grips. Use the smaller of the two.
Figure 26 transport lock and rubber grip installation

PTO SHAFTS

The PTO shaft with the one-way clutch shown in the picture below is installed between the 3
point hitch and the drum unit. Install the thicker clutch end so that it is attached to drum unit
(see Figure 27).
2021-1.2 IBEX EQUIPMENT CO. 15