Advertisement
Quick Links
Advertisement
Related Manuals for IBEX TS100
Summary of Contents for IBEX TS100
- Page 1 QUICK START GUIDE TS100 Belt Rake IMPORTANT READ BEFORE FIRST USE 2022-1.0 IBEX EQUIPMENT CO...
-
Page 2: Assembly Tips
Inspect your rake upon arrival. Check all sides for any damage that may have occurred during shipping. If you see any damage, take pictures and contact your IBEX dealer. Once inspected, remove all protective plastic wrap from the rake (Figure 1). - Page 3 Figure 4 Figure 5 Remove the lag bolts that are holding the main three point hitch in place (Figure 6). Then cut the banding holding the back of the belt rake frame (Figure 7). 2022-1.0 IBEX EQUIPMENT CO...
- Page 4 Now that the belt rake is no longer secured to the pallet, insert a block of wood to support and lift the front three point hitch of the rake to allow for the tractor to be hooked up (Figure 9). 2022-1.0 IBEX EQUIPMENT CO...
- Page 5 Back your tractor up to the three point hitch of the rake and hook up to the three point hitch of your tractor to allow for further assembly of the wheels (Figure 10). Figure 10 2022-1.0 IBEX EQUIPMENT CO...
- Page 6 (Figure 11). Shortening the top link can help tilt the rake further upwards in the rear if needed to get enough clearance. Figure 11 Remove the allen head set screws from the wheel caps on each side (Figure 12). 2022-1.0 IBEX EQUIPMENT CO...
- Page 7 Make sure the set screw is properly seated in the groove at the top of the wheel arm. DO NOT over-tighten the set screws as this will compress the screw against the arm and prevent the wheel from being able to pivot. 2022-1.0 IBEX EQUIPMENT CO...
- Page 8 Locate the bag of hardware that came in the parts box. Install the side guard panels using the provided bolts and nylon lock nuts as shown in (Figure 16). Use a small amount of thread locker on these bolts. 2022-1.0 IBEX EQUIPMENT CO...
- Page 9 Figure 16 Install the tines as seen in (Figure 17), making sure the tines fit into the grooves on the tine holders. Use a little dab of thread locker on these bolts as well. Figure 17 2022-1.0 IBEX EQUIPMENT CO...
- Page 10 (Figure 18). Figure 18 As with any new implement, the shaft that attaches to the tractor may need to be cut to length. Consult the included Ibex Equipment PTO Shaft Cutting Guide. 2022-1.0 IBEX EQUIPMENT CO...