IBEX TS51C Assembly Manual page 3

ASSEMBLY GUIDE
Figure 12 move the drum unit over to the three point hitch assembly like this ......................... 9
Figure 13 swivel tee assembly .................................................................................................... 9
Figure 14 the cap and hardware are shown here for the swivel tee ........................................ 10
Figure 15 swivel tee in place for next step ............................................................................... 10
Figure 16 short swivel pin ........................................................................................................ 11
Figure 17 align holes in arm to swivel tee ................................................................................ 11
Figure 18 holes aligned to allow pin to pass ............................................................................. 12
Figure 19 pin through and nut started ..................................................................................... 12
Figure 20 top spring arm installed with pin blocked up by using a 2x4 .................................... 13
Figure 21 hardware to attach spring arm to lower arm............................................................ 13
Figure 22 top spring arm attachment to lower arm ................................................................. 13
Figure 23 push the lower arm down to line up with drum unit ................................................ 14
Figure 24 holes are close to being aligned ............................................................................... 14
Figure 25 nut and washer installed on pivot pin ...................................................................... 15
Figure 26 transport lock and rubber grip installation ............................................................... 15
Figure 27 connect the driveline with one-way clutch ............................................................... 16
Figure 28 guard chains attached .............................................................................................. 16
Figure 29 shaft with slip clutch end .......................................................................................... 16
Figure 30 restrictor plate with hardware ................................................................................. 18
Figure 31 pivot restrictor plate and handle shown installed from side .................................... 18
Figure 32 front guard has six holes .......................................................................................... 19
Figure 33 eight sets of fasteners used for attaching guard frame ............................................ 19
Figure 34 curtain installed with 2 holes for toe guard facing forward ...................................... 19
Figure 35 curtain straps secure to the guard frame ................................................................. 20
Figure 36 safety release bar ..................................................................................................... 20
Figure 37 correct oil level in drum gearbox .............................................................................. 21
2021-1.2 IBEX EQUIPMENT CO. 2