IBEX TS51C Assembly Manual page 13

ASSEMBLY GUIDE
Figure 18 holes aligned to allow pin to pass
Drive the pin through. Fit the washer and the nut. The nut takes a 30mm wrench. Do not over
tighten, just snug. Use a screwdriver, or something that will fit through the hole in the round
head to keep the pin from turning.
Figure 19 pin through and nut started
The top spring arm will fit onto the top cap as shown. Again, do not over-tighten as it needs to
be able to pivot. Before removing the bolt from the top cap, raise the three point hitch on the
tractor and cut a 2 foot length of 2x4 to support the lower arm. Let the three point hitch down
so it is resting on the 2x4. This way the pin will not fall out of the hole when the hardware is
removed on the top.
2021-1.2 IBEX EQUIPMENT CO. 12