Hardware Guide; Pto Guard Installation - IBEX TS51C Assembly Manual

ASSEMBLY GUIDE
Figure 2 hardware

Hardware Guide

A. Top link pin
B. 3-point hitch pins (
C. Transport lock (
D. Pivot restrictor handle (
E. Pivot restrictor plate (
F. Drum mower blades
G. Spring arm nut/bolt (
H. Stand retention clip (

PTO GUARD INSTALLATION

Install the plastic PTO guards. They are easier to install before assembling the mower. Use the
set of 4 screws and washers provided in the hardware bag to install the larger guard on the
gearbox facing the tractor as shown in Figure 3. Note that this guard may appear somewhat
different, and may already be installed on the gearbox.
2022-1.1 IBEX EQUIPMENT CO.
)
Figure 6
)
Figure 19
)
Figure 23
)
Figure 23
)
Figure 15
)
Figure 18
I. Pivot restrictor handle washers (
J. Curtain frame nuts/bolts (
K. Hardware for large PTO guard (
L. Hardware for small PTO guard (
M. Hardware for transport lock (
N. Hardware for pivot restrictor plate (
O. Roll pins to retain 3 point hitch pins
P. R-clips to secure breakaway bar (
)
Figure 23
)
Figure 25
)
Figure 3
)
Figure 5
)
Figure 19
)
Figure 23
)
Figure 28
4