IBEX TS51C Assembly Manual page 15

ASSEMBLY GUIDE
Figure 23 push the lower arm down to line up with drum unit
The centers must be lined up before driving the pin through the hole. Use a long screwdriver,
long punch, or something similar to line up the holes. Do not force the pin through, as you can
damage the plastic bushings. A little oil on the pin can help. Use the top link to adjust the angle
and adjust the three point hitch height on the tractor to better line up the holes. Use patience
as the pin will not go through easily until it is lined up well. Try nudging the drum unit to get all
holes aligned at the same time.
Figure 24 holes are close to being aligned
Install the washer and nut on the pivot pin. The nut is a nylon locking nut and should not be
over-tightened.
2021-1.2 IBEX EQUIPMENT CO. 14