IBEX TS51C Assembly Manual page 12

ASSEMBLY GUIDE
Next get the shorter of the two swivel pins as seen in Figure 16. It usually has the washer and
nut attached.
Figure 16 short swivel pin
Align the two holes on the support arm so that they centered to the bushing. The pin will not
go through and the plastic bushings could be damaged if the holes are not well aligned first.
You can use an adjustable height stand such as a chair to hold up the arm while aligning the
holes. Take note of the orientation of features so that it is installed right side up.
Figure 17 align holes in arm to swivel tee
Adjust the centers of the holes to be concentric and well-aligned before attempting to push
the pin through.
2021-1.2 IBEX EQUIPMENT CO. 11