Headset; System - ASCOM d83 User Manual

USER MANUAL
Ascom d83 DECT Handset
The headset button can be configured with a specific function, such as post-dial, dial last called number, or
dial a predefined number. For more information, refer to the Configuration Manual, Ascom d83 DECT
Handset, TD 93426EN.
A paired Bluetooth headset is automatically connected, which is indicated by a colored square
of the headset.
If the connection with a headset is lost it will try to reconnect. The pause between attempts starts from 1
second then it increases after each failed attempt by 1 second. After 10 minutes approximately the pause
between attempts reaches 30 seconds and isn't increased anymore.
If a connection is not restored during 2 hours the Bluetooth handset stops the reconnecting process.
8.1.2

Headset

In order to achieve optimal audio quality with the different headset types, it is recommended to select the
corresponding headset profile.
The default setting is microphone on a boom, that is, the audio is optimized for using a headset with
microphone on a boom. The headset profile can be changed in the menu by doing the following:
1. Select Headset.
2. Select the corresponding headset profile from list, that is Mic on boom, Mic on cable, or Customized
headset profile .
1
3. Press Select.
8.1.3

System

The handset can subscribe up to eight different systems.
Change System
Select Automatic or a specific system. If the handset is set to Automatic it selects a system according to
the priority list, see Priority, page
Subscribe Handset in IP-DECT System using Easy Registration
A handset can subscribe to an IP-DECT system automatically if the following are fulfilled:
• The IP-DECT system is configured for Easy Registration. Refer to the corresponding Installation and
Operation manual for the IP-DECT system.
• The handset's IPEI is registered in the IP-DECT system. Refer to the corresponding Installation and
Operation manual for the IP-DECT system.
• The handset is not subscribed to any system.
1. If needed, switch off the handset by pressing
2. Switch on the handset by pressing
3. Select language to be used or press Cancel. If Cancel is pressed, the default language (English) will be
used.
4. The handset starts to search for IP-DECT systems and will subscribe to the system when it is found.
1. Customized headset profile is only visible if the headset profile has been configured in WinPDM/Device Manager.
TD 93434EN / 01 December 2021 / Ver. B
53.
.
.
Menu Operation
in front
51